Clothes off love is on the way how long does it tkae

Overlap the binding half its width over the raw edge straight-stitch it into place. For loosely woven fabrics or where you want to avoid bulk, finish the raw hem edge with seam binding use ribbon or lace binding for straight hems, bias binding for curved or flared hems. For fabrics that ravel easily, straight-stitch along the edge of the hem, 1/4 inch from the edge overcast the edge by hand or with a zigzag machine stitch. For lightweight woven fabrics, turn the raw edge under 1/4 inch and straight-stitch it. For fabrics that don't ravel much, straight-stitch along the edge of the hem on a sewing machine, 1/4 inch from the edge pink the edge with a pinking shears. Measure up from the crease into the hem allowance and trim the hem to the correct width all around.Д«efore stitching the hem into place, you must finish the edge of the fabric if it is raw.

For most garments, 1 to 2 inches is a good width for hems - use 1-inch hems for sleeves or pants legs, 2-inch hems for skirts or jackets. Leaving the hem turned up, adjust the hem allowance as necessary to make an even hem, about the same width as the old one. Make sure the hem is plainly creased all around the garment. If you're hemming sleeves or pants legs, use a sleeve board as necessary to press the hem. Turn the fabric up at the marked hemline and press it firmly to crease the new hem remove the pins as you go. Take the garment off and set it on an ironing board, wrong side out. Stand straight and turn slowly as your helper marks the new hem. To make sure all pins are placed correctly, measure from the floor up with a yardstick or a skirt marker. Have your helper mark the new hem with straight pins at the desired point keep pins close together. Stand in front of a mirror, in good light. Then put the garment on.ДЇor the best results, work with a helper to mark the new hem. If you're lengthening the garment and the old crease shows, sponge the crease with white vinegar and press it with a damp pressing cloth. Remove the old hem and press out the crease with a steam iron. The most common problem with new clothes is the hem - too short, too long, or uneven. Time: 1 hour or more, depending on alteration needed.

Materials: white vinegar ribbon, lace, or bias seam binding, or wide bias seam tape thread, fabric as necessary, paper.

Clothes off love is on the way how long does it tkae